Girth hitch sling personal anchor This may be another sling, a pole, or the belay loop on your climbing harness. But notice, that's not what's happening here. If this is the case, double one sling and extend it with a quickdraw or connect another second sling to the first with a girth hitch; There is a typical anchor setup used by lead climbers on sports routes, and you can use it for toprope too: Clip a single quickdraw to each bolt and clip the rope through the lower carabiners. Of course 1 person(the second) is going to need a sling and a binder to clip the master point or the shelf. Agreed. Dec 12, 2017 ยท More comparison of girth hitch to harness reduction in strength to looping around 1” steel pins; Etc. This setup is somewhat standard practice for abseiling here in Switzerland, where you tie a 120cm sling to your harness, make a knot at about 2/3 length and attach your backup (prusik) to your harness, the braking device (e. no need for a purcell or PAS just girth hitch a sling from your tie in point and clip into the anchor, keep the sling weighted so you can't fall on it. it's dangerous. If you’ve been paying attention at the crag or to social media, you might have seen a girth hitch used as the masterpoint of a belay anchor—like, tied in the cordelette or sling the masterpoint locker is clipped to. wucindfmrhicedombwwchcckewecqjbquchfkxdvlbefojopdxunpfzzqpkgmwurauvwyoue